This craft is amazing. We will convert a water bottle to a fantastic bland lighting headlamp truth. The idea is to entice more kids, but also adults that I see coming few lighthouses-lamps in all rooms. Best of all, it's very simple. Would you do it? Here we go!
To make the lighthouse will need:
A large bottle of water.
Cutter.
Cola.
Foil.
Red acrylic paint.
Black tape.
Plasticine.
A flashlight.
Role of rubber eva foam or white.
Transparent tape.
First, the bottle cut in two by means of a cutter. The incision should be a little higher than half, but not much. We turn to the part where is the plug and pour a splash of white glue. Then we added the aluminum foil in a circle with the diameter of the bottle, as if we create you a kind of soil. We let the glue dry.
Then paint the top of the bottle with red paint. We give a coat, let it dry and give another. Again let it dry. When the paint is dry, apply three strips of tape black with decorative function. All three must be equidistant to the extent possible.
On the other side of the bottle, we introduce a generous ball of dough. Then we put up the lantern and crush to penetrate the clay and locks. We can bring the flashlight switch to one of the edges, as this will facilitate access. The next thing to do is cut with a utility knife or scissors a hole in front of the switch, so you can play. It's like a window.
After that, we surround the bottle with the rubber eva foam or paper making sure that all that half is covered and is slightly above the flashlight. Before you seal it with transparent tape, dial in what place is the switch, or tapiaremos! To that extend the material on a flat surface and put the bottle top. With a pencil, we can draw the lines and then cut the rectangle without problems.
Once fixed foam paper, we just have to put the top of the bottle and wrap colored tape black foam to paper. It's easier than it sounds, honest.
You can decorate the switch so it is not as exposed, although you must be careful with the material used.
A large bottle of water.
Cutter.
Cola.
Foil.
Red acrylic paint.
Black tape.
Plasticine.
A flashlight.
Role of rubber eva foam or white.
Transparent tape.
First, the bottle cut in two by means of a cutter. The incision should be a little higher than half, but not much. We turn to the part where is the plug and pour a splash of white glue. Then we added the aluminum foil in a circle with the diameter of the bottle, as if we create you a kind of soil. We let the glue dry.
Then paint the top of the bottle with red paint. We give a coat, let it dry and give another. Again let it dry. When the paint is dry, apply three strips of tape black with decorative function. All three must be equidistant to the extent possible.
After that, we surround the bottle with the rubber eva foam or paper making sure that all that half is covered and is slightly above the flashlight. Before you seal it with transparent tape, dial in what place is the switch, or tapiaremos! To that extend the material on a flat surface and put the bottle top. With a pencil, we can draw the lines and then cut the rectangle without problems.
Once fixed foam paper, we just have to put the top of the bottle and wrap colored tape black foam to paper. It's easier than it sounds, honest.
You can decorate the switch so it is not as exposed, although you must be careful with the material used.
No comments:
Post a Comment