If you want to renew your christmas star tree and can not find any in the stores that you like, be encouraged to do it yourself.
The materials you need are:
Hands ... First step : let's make the base of the star. This should take the plug and the fine wire and make a coil from 3.5 to 4 inches long around the pin. The long vertical branch depends on the top of your tree is placed gift of the star and the star height are going to make. If it is larger, because the length of the coil you do should be higher and consequently the greater the total length of wire sconce will vertenral column of the star. When you already have one ready, like the one in the picture, you should take the pliers and cut the remaining wire utlizarás not. Finally, you must remove the plug.
Second step : let's make the star. First you print the star cast. The link is below. To extend it you can do with a copier and give you the size you need. With this mold you cut two stars on the corrugated cardboard. Help yourself with the stylus and the cutter to mark and cut. Be careful not to damage the table or surface you're working with the cutter. Keep in mind that all lines are out in the mold to work the star and we stay two pieces in three dimensions, as seen in the photos. Are those lines clearer and darker the help you finish the star so that you have that. Likewise, you should be aware that the smooth side of the cardboard is what should be out. Not so the corrugated cardboard, which is what should be facing inside the star, in the unseen.
When you already have the two sides of the star completed, take one of them and in the center, in the inside cotton or paper must place arrugaldo along with smooth shank wire. That must be inside the star, forming part of its fill, pattern making photography.
then take the clear tape and place it in each tozos small and the tips of the star in order to unite with the other side of it. Pegas and all tips and you have left the star's body ready.
Third step : let's put the final touches to the star. Tomas glue spray and you spray both sides of the star. Immediately after you take the glitter or glitter glue and sprinkle on the star until it is evenly covered. If it is necessary to repeat the procedure, do as many times as necessary. Let dry thoroughly and then take the small lameta.
must place with the hot glue gun, glue around the star and go lameta sticking around it. Take the picture as a guide then exits. When finished, let the glue dry thoroughly and estpa and ready to use.
- Cardboard microcorrugated.
- Scissors.
- Cuter.
- Spray adhesive.
- Hot glue gun.
- Brilliant tone.
- Lameta small.
- Fine wire.
- Plug.
- Pliers.
- Rule.
- Small transparent tape.
Hands ... First step : let's make the base of the star. This should take the plug and the fine wire and make a coil from 3.5 to 4 inches long around the pin. The long vertical branch depends on the top of your tree is placed gift of the star and the star height are going to make. If it is larger, because the length of the coil you do should be higher and consequently the greater the total length of wire sconce will vertenral column of the star. When you already have one ready, like the one in the picture, you should take the pliers and cut the remaining wire utlizarás not. Finally, you must remove the plug.
When you already have the two sides of the star completed, take one of them and in the center, in the inside cotton or paper must place arrugaldo along with smooth shank wire. That must be inside the star, forming part of its fill, pattern making photography.
then take the clear tape and place it in each tozos small and the tips of the star in order to unite with the other side of it. Pegas and all tips and you have left the star's body ready.
must place with the hot glue gun, glue around the star and go lameta sticking around it. Take the picture as a guide then exits. When finished, let the glue dry thoroughly and estpa and ready to use.
No comments:
Post a Comment