Floral decoration for phone protector

Spring!, So we can qualify this colorful and beautifully decorated. With it you will be the envy of your friends, you will have the cell phone pouch and more beautiful and original. We will show you step by step how you can make this beauty in no time.

It really is wonderful, and you will not regret if you do not quite like any of the proposals can always put your personal touch to make it truly unique and original.

List of materials needed:

• Dried flowers pressed
• Hard case or cover for your mobile phone
• Transparent glue
• A flat work surface level
• Tape
• Scissors
• Paper
• Rule
• Fine point permanent marker
• Two clear plastic cups
• Two flat wooden sticks
• Two component epoxy resin transparent
• Timer
• Purpurin

To begin place the pressed flowers on the housing and try different floral arrangements. If you want to put many flowers make sure they do not protrude more than 1.5 mm above the level of the housing or can not properly coated with resin housing. Note that being pressed flowers become slightly transparent once they are coated with resin, so look better if we put the lighter color underneath. Once you have found an arrangement you like taking a picture of it for easy reference later.

When we have determined the distribution of the flowers go a little sticking with transparent glue. Gradually, the largest below and the other above.

 We will follow the instructions meticulously recommended by the manufacturer, according to the epoxy resin have purchased. You have to be very precise with the amounts and times if you want to get a correct result.

We will plant baking paper on the desk and I look with a few pieces of tape. Then pour resin slightly above the flowers of the housing.

We extend a wooden stick to cover up the entire surface. Add a little more resin if we do not have enough. It is better to fall short to the contrary, if we miss the resin casing surface can roll a good scrub down.

Once we let the housing coated resin dry time recommended by the manufacturer, one to two hours is usually as normal. Will blow on the resin to break any air bubbles that may form. With a cotton swab and a little acetone can clean any small resin overflow the sides.

As the resin layer dries go over to observe any possible failure, we can apply another layer of resin to correct any error or fault.