The Ladies Only: Bead Goldfish

Materials needed:
1. Thick wire (for the body).
2. Transparent beads, red, orange (I number 10 Chinese).
3. Sequins red, silver.
4. Black beads 2 pieces (for the eyes).
5. Transparent silicon (to simulate the water).
6. Gypsum.
7. CD-disc.
8. Pebbles and seashells.
9. Glue.
10. Thin wire (for the tail).
11. Glue gun (hot glue).
12. Self-hardening mass for molding.

Take a thick wire to the frame. Better to mark the desired length on the wire body and tail of the fish, add about 5-7 cm on the loop, which will fill with plaster. Bend the wire with the letter D, make a loop. Spread the plaster with water, put the disc on the wire, place the framework to the mix. Slightly pushing the drive trim the edges of gypsum mixture around the circumference of the disc. After drying, the disc will fall behind the plaster. Glue it with glue. I use glue Titan. Here's what you should have:

Paint the frame with white paint or nail polish.

Dial sufficient transparent beads on thin wire winding frame. Securing the wire at the bottom, wrap the frame to the place where the body is expected to begin. Secure.

Tail.
first tier is designed to mask frame.

On thin wire type in a few red beads, then randomly alternate between red, orange and clear. Bottom tail - transparent beads. Low length must be a little more length of the chassis. Secure the edge beads, wire skipping through them again. Leave the tails. Make 5 beams 5 "feather" have in each. Twist the wire tails on both sides.

Strapped bundles of thread, placing them around the tail of the frame.

The second tier is designed to give volume tail. Low to be of such length that the tail was slightly wavy. Try on a low-to-tail. Number of beams of the second tier depends on the desired splendor tail.
Not fixed at the bottom trim the tails beams cutters, leaving about 0.5 cm to stick. Pre-position the tails beams so that the tail you like, give undulation. Hot glue stick wire tails to the disk. Designated bonding zadekoriruyte stones, seashells.
Fins.

All are made the same way (see photo). The only difference in height and number of rows. Do not forget to leave the tails (they hide themselves in the body of the fish).

The body of the fish.

From self-hardening mass blind by fish body, closing frame. Schedule head. Insert the black beady-eyes, fins. Give the weight should be as cool.

Pasting sequins.

If the mass is not white, it is desirable to paint before pasting. Advance which will mark the red spots. Glue sequins body from the tail (I glued on the glue Titan). Sequins have staggered like a scale at this fish.

head cover with silver sequins.