LACQUERED CLIP-NAIL POLISH FLOWER

Here's a Clip occurred to me to make... So, let's start ...

We need: 
* wire (0.3 mm) 
* nail polish (preferably not too thick and not too runny) 
* wire cutters 
* clay 

* ballpen       

we will cut about 5 identical pieces of wire, not very large 8-10cm

bend the wire in half and twirl like this

here is to get the ring

give it shape petals, pressed to handle

when viewed from the side, it should turn out like this

Now the hardest part: 
Generously brush dipped in nail polish, stretch the large drop from the brush across detali.Ne fact that the bubble will pull the lacquer on the first try. 
Brushes must be held at the lowest possible angle to the plane of the craft. Try to keep the top and bottom brush crafts. It was easier to do it from the bottom. 

Varnish taut and not burst? Excellent. Now cant crafts in the right direction, so that it flowed evenly as you need.

You can combine colors, but be careful, the bubble could burst!

wait until it dries a little thing, I was drying, sticking a piece of plasticine petals

stamens .... Again wire cut into small pieces and gently put on the tip of the paint-droplet

Curl up together ... voila! Obtain flowered)

here's a Clip bunch of flowers can be made from these flowers

Preferred to work with  the items, the dimensions of which are comparable to the size of the brush with nail polish. If the item is much more, it is very difficult to pull on her nail polish