Flowers from plastic bottles

Tools and materials
• plastic bottle green (5-6) and the transparent color (7)
• scissors;
• awl;
• PVA glue;
• Master glue;
• acrylic paint, alkyd aerosol (red, yellow);
• candle diameter 2 cm;
• green electrical tape;
• wires of different diameters;
• Large beads of two colors;
• oblong and round beads;
• thick threads (the iris).

Stages of drafting a bouquet of flowers
Making the core
1. Produce from large beads, beads 7 pistils and stamens 42.
To manufacture a fine wire take pistil length of 20 -25 cm her bead strung on green bend the wire in half and the two ends of strung beads 22 large green.

For the manufacture of thin wire stamens take a length of 20 -25 cm strung on her elongated bead, bend the wire in half and the two ends of strung beads 19 blue (white) color.

2. To gather a flower, you have to take one pistil and stamens 6. Pistil attached to the aluminum wire thread length20 cm, Lubricating wire with white glue, and stamens spread around evenly and hold them thread.

Making flower
1. At 7 transparent bottles, cut off the top.

2. Each part cut into 6 equal strips to the neck. From the top of each strip cut petals rounding top.

3. Each petal process over the candle, giving a rounded shape petals. Initially process between the petals, and then the edges of each petal, fingers clutching the other petals.

4. Then painted in 2 layers each flap wheel on both sides red alkyd paint. Better paint on the street. In his left hand holding a flower, wearing a plastic bag on his hand, and his right hand evenly spray paint on it from the container. After drying the middle of the flower turns yellow.

5. First awl to pierce the stopper and then shears. In the lid to pour a little glue Master, and the connection of stamens and pistil well greased with white glue and pull the hole in the tube, spread stamens. Ready to put in a flower vase or jar until the glue.

6. The flowers paint tube green or turquoise paint, the color of the tape. After drying, wrap the wire with electrical tape.

Leaf Fabrication

1. From bottles (5-6 pcs.) Cut green oblong leaves of different sizes. Large leaves 8-10, smaller - 4 leaf, small - 4 leaves.

2. Process each leaf over the candle. Initially, the contour of a leaf, and then at the bottom of the front side to leaf slightly straightened.

Pierce a hole at the bottom with an awl, insert the wire and fix it.

3. Wire each leaf wrap tape.
Assembling the bouquet

1. To long (1 m) Thick wire, pre-lubricated upper part PVA glue, primotat flower thread.

2. After the glue dries down from the flower wrap tape 20 cm  3 threads and tie flower, a little pre-bent stems.

3. When the glue dries, wrap the tape down the stem 25 -30 cm primotat thread and 3 more flower stalk lubricating PVA glue and flowers placed between the flowers of the previous row.

4. After the glue dries, wrap the tape and attach 2 small leaves. Again wrap duct tape and secured by 2 - 3 large leaf, then the last 2 medium and small.

5. When the glue dries, wrap the tape to the end.

The finished bouquet of flowers to decorate the site.