The Ladies Only: NIGHTLIGHT FOR THE FAIRIES

Really love when a soft diffused light ... and to their hands, and if still nothing, only paper and imagination - it's all wonderful. Here are found all in one bottle. And to show you!

That such words I want to start fasting. Often in life circumstances are such that we need a light in the midst of darkness ... namely night. When the baby is awake or when you just wanted to "drink of water"))) ... I do not always want to include "common" light, especially if someone else in the room resting. And here can help small nightlight, standing next to the dresser or shelf. It can also serve as a decorative element in your room. Or just create a romantic setting))) It is necessary to turn off the lights ... and turn on a nightlight. Here for such purposes, we offer you to make a night light with their hands.

For manufacturing, we need a box of tea. It will serve as the foundation of our lamp.

1. From scrap sheet of paper cut out a rectangle the width of banks (in my case 15 cm) and paste it to the bank.

2. Important point! Astride our nightlight will serve low banks. This is important if the direction of the drawing paper matters.

3. Removing the cover banks and encircle it on paper. It will be our preparation for a "window".

4. At our bank have cut blank and attach it masking tape. And passing the pencil, thus we plan the location of our "window".

5. Now carefully stationery knife cut our window. This is best done in three stages. First, we lightly pressing the knife, hold on a path. So we leave the "furrow". In the second stage we push more strongly (here you should "fall" oval scrap of paper and label). At the third stage we push hard, and cuts himself cardboard boxes.

6. Take a piece of sandpaper and "fine tuning" edge of the window.

7. acrylic paint paint the 'window'. Do not be afraid to leave paint the edges, thus adding an element of decoration.

8 . At not very thick cardboard impose our billet-oval. Passing the pencil. Draw stripes and shades those strips that the end result must remain visible.

9. Now our "window into the lattice" we slightly arching. And with adhesive glue inside banks, closing our cutout.

10. The next step we decorate our nightlight.

11. the reverse side of our nightlight Installer eyelets make two holes for threading in the future they cord.

12. Now with the help of male power (if it is good to ask, always help))) cut a hole in the lid (this can be done with a kitchen knife). Radius of the hole radius must meet the cartridge.